Burigotto Leblon Instrucciones De Uso página 12

Ocultar thumbs Ver también para Leblon:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
3• To slacken the harness, insert a finger through the seat
opening, keep the metal button pressed, and with the
other hand pull on the straps.
To release the harness, press the red button on the
crotch strap buckle and remove the straps.
4• The safety straps are adjustable in height in 2 positions
to suit the growth of the child. To adjust the height,
open both straps and slide them back out of the holes
in the body and insert them back into the holes at the
desired height.
5• Adjust the height so that the straps are just below the
child's shoulders.
6• The seat is equipped with a booster cushion for
newborns, to be removed when the child is older.
7• The car seat handlebar has 3 fixed positions. To rotate it,
press the two buttons on the handlebar and move this
to the required angle. Ensure it clicks into position.
Position 1: the position for transport by hand and for
installation on a stroller or chassis;
Position 2: allows the car seat to rock;
Position 3: stops the car seat from rocking;
8• To fit the hood, insert the hood attachments into the
openings on the car seat and arrange the rear part of
the hood behind the backrest.
IMPORTANT: The hood must not be used to lift
the car seat because it might detach.
9• To use the car seat on the stroller, attach the car seat to
the special attachments of the stroller, as shown in the
picture.
To release it, press the buttons located next to the
handle and at the same time lift the car seat.
Instructions for in-vehicle use
10• Fit the car seat with the child seated inside,
remembering to secure the child with the harness.
11• Slide the vehicle seatbelt into the two car seat lateral
guides and buckle it, ensuring the seatbelt is taut, as
shown in the figure.
12• Take hold of the vehicle seatbelt again and pass it
behind the backrest of the car seat, inserting it into the
rear guides as shown in the figure.
Tighten the seatbelt.
Removing the soft cover
To remove the car seat cover:
• remove the hood
• press the red button on the crotch strap buckle to
release the harness
• remove the booster cushion, if present
• remove the shoulder pads
• remove the straps from the backrest
• remove the soft cover
Maintenance of the padding
Brush the fabric parts to remove dust.
• When washing, closely follow the instructions stated on
the label sewn into the cover.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido