Veratron VL FLEX 52MM Serie Manual De Instrucciones página 15

1. READ CONFIGURATION
Open the "VL Flex Configurator" app and read the
current configuration of the device by "touching" the
front lens of the device with the smartphone.
The READ operation is mandatory before the WRITE
operation is allowed.
After reading, the app is set with the current
configuration of the VL Flex.
Note: The position of the antenna on the smartphone
depends on the model.
For more information, refer to the smartphone
manufacturer's manual.
2. SELECT DISPLAY LAYOUT
Use the Layout section to choose between single and
double image layouts.
The preview image at the top of the app screen will
update accordingly.
When Dual Layout is selected, the app expands the
device settings to be able to configure both fields of
the screen.
3. SELECT DISPLAY TYPE
Use the Gauge Type item in the Data Selection
section to select the data to be displayed on the VL
Flex.
If the dual layout is selected, you can select the data
for the upper as well as for the lower part of the screen
separately.
Note: For the complete list of supported data types,
see the Supported Configurations table in this
document.
4. SELECT MASS UNITS AND INSTANCE
CONFIGURATION
B000882