Supported Configurations - Veratron VL FLEX 52MM Serie Manual De Instrucciones

Define the unit of measurement for the displayed
data. (see table "Supported configurations").
Set the instance for the displayed data (e.g. engine
number or tank number) so that they are shown
correctly on the display.
Some rudder position sensors send their data on their
own instance instead of the associated instance of the
engine. In this case, the "Ignore" option must be
selected as the Engine Instance.
Note: The defined instance is also used by the VL Flex
when receiving data from NMEA 2000®.
5. ALARM SETTINGS
For some data types an alarm can be set (see table

"Supported configurations").

The alarm can be activated or deactivated via the
corresponding switch in the app.
Once the option is enabled, the threshold value can
be set using the corresponding numeric field.
The unit of the alarm threshold is the same unit that
was defined in the previous step.
Note: The "direction" of the alarm threshold (up or
down) is predefined (see table "Supported
configurations").
6. CALIBRATE SENSOR
By default, the VL Flex assumes that data is received
via NMEA 2000® , so the analog inputs are disabled.
If a sensor is connected via an analog connection
(resistance or frequency), it can be configured by
activating the corresponding switch in the app.
Note: Depending on the type of display configured,
only one of the available inputs can be assigned to the
data type. (see table "Supported configurations")
If a dual layout (two values) has been selected, you
can select which data is to be configured as an analog
input.
The other data is considered to be received from the
NMEA 2000® network.
CONFIGURATION
B000882