Checking The Installation - Thermo King C Serie Manual De Instalación

• All holes should be sealed with silicone or foam.
• Check with a sheet of paper that the fans blow in the right direction.
• The drain circuit should be on an incline and the moisture trap should be installed.
• Position the hole at the expansion valve.
• The temperature sensor should be connected.
• The in-cab control box should be located in such a way that it is accessible and visible
from the driver's seat.
• The contact draw should be made.
• Hoses should not be taut (they should be able to absorb vibrations and be shortened
in case of leaks).
(Rev. 3, 05/11)

CHECKING THE INSTALLATION

• Hoses should not rub against moving parts, sharp parts, or parts that can reach high
temperatures.
• The oil return should be connected.
• The compressor should be primed with oil.
• The unit should be connected to the battery.
• The drive kit test should have been carried out.
• The seal test should have been carried out.
Eng
46