Operation instructions
How to use your vacuum cleaner
Ensure the vacuum cleaner is fully charged and assembled before using.
Always take care when vacuuming stairs.
1. There are two power settings on the stick vac: max mode (this has a
higher suction power but a shorter running time, approx 15 mins) and
eco mode (lower suction power with a
longer running time, approx 45 mins).
The stick vac will always start in max
mode. The run time may vary depending
on the surface being cleaned.
2. For the 'max' mode simply press the
power button (1), while for 'eco' mode
press the power button (1) followed by
the mode button (2). The max operation
light will illuminate when in 'max' mode
and go out when switched to 'eco'
mode.
When required, press the power button
again to turn off the stick vac.
3. Move the floor head back and forth over the surface. Use even
strokes. Don't press hard; allow the stick vac to suck away the debris.
There are lights on the floor head which will illuminate automatically
when the stick vac is in operation to help with visibility in dark corners/
areas.
4. The stick vac has charge indicator lights, these are the two small lights
on the handle.
Whilst charging - the lower light will flash and the top light is off
Half charged - the lower light is on and the top light will flash
Fully charged - both lights are on, will turn off after 10mins
When in use and the battery is almost gone, the bottom light will be
off and the top light will flash. After approximately 10 seconds the
stick vac will automatically switch off.
5. It is advisable to empty the dust cup after each use. For best
performance, check the filters are clean (see the 'Removing and
cleaning the dust cup and filters' section of this manual).
2
6