Control Panel - Sekey Home 3002 Manual De Instrucciones

OPERATING INSTRUCTIONS

Control Panel:

Main Power Switch (A)
Open the cover and push button A down (I) to "ON" position.
ON/OFF(B)
Press button B (ON/OFF) to start the flame effect.
Default interface displays as follows:
There are two short high-pitched beeps when turned on, and three low-pitched beeps
when turned off.
When switched on, the heating level, set temperature and clock icon will display. The
display will disappear when there is no operation for 60 seconds. Press any button to
display again.
Lock the Buttons(C)
Press and hold button C (OK) for more than 6 seconds to lock or unlock the buttons,
LOC displays and indicates that the buttons are locked. Once it's locked, LOC will flash
for 6 seconds and then disappear. Press any button and LOC will flash again. Long
press button C (OK) for 6 seconds to unlock the buttons.
Please note the button B (ON/OFF) is never locked.
B
 It will display the heating icon and start heating when
the room temperature is lower than the default setting
(10°C), on the contrary, it will not display the icon or
heat.
 The clock icon will flash when the time is not set yet.
Please follow the steps in "Time Setting" to set the
time.
C
D E
A
7
F