English - Bosch EasyLamp 12 Manual Original

English

Safety instructions for cordless worklights
Read all the safety and general instructions. Failure to observe the
safety and general instructions may result in electric shock, fire and/
or serious injury.
Save all safety and general instructions for future reference.
Handle the worklight with care. The worklight produces intense heat which in-
u
creases the risk of fire and explosion.
Do not work with the worklight in potentially explosive areas.
u
Do not continue to press the On/Off switch after the worklight has been auto-
u
matically switched off. The battery can be damaged. Ensure that the battery is
charged and that the worklight has cooled before switching on the worklight again.
Use only original Bosch accessories.
u
The light source cannot be replaced. If the light source is defective, the entire cord-
u
less worklight must be replaced.
Remove the batteries from the worklight before carrying out any work on the
u
worklight (e.g. assembly, maintenance, etc.) as well as when transporting and
storing the worklight. There is risk of injury from unintentionally pressing the on/off
switch.
Do not direct the light beam at persons or animals and do not stare into the light
u
beam yourself (even from a distance).
Do not use the worklight in road traffic. The worklight is not permitted for illumina-
u
tion in road traffic.
NOTE: Do not look into the light beam for prolonged periods. The op-
tical radiation may harm your eyes.
Do not cover the lamp head while the cordless worklight is operating. The lamp
u
head warms up during operation and can cause burns if this heat accumulates.
Do not allow children to use the cordless worklight. It is intended for professional
u
use. Children can unintentionally blind themselves or other persons.
In case of damage and improper use of the battery, vapours may be emitted. The
u
battery can set alight or explode. Ensure the area is well ventilated and seek med-
Bosch Power Tools
English | 11
1 609 92A 8AN | (18.08.2022)