Chip Extraction; Blade Change - Mafell ZH320 Ec Instrucciones De Funcionamiento Y Seguridad

4.3 Chip extraction

The carpenter's planer is designed such that proper chip ejection is ensured when planing at proper feed rate
and fully utilized planing width. In this process, the chips are ejected sideways so that the view of the
workpiece is not obstructed.
For all work that produces a significant amount of dust, connect the machine to a suitable external extraction
device. The air velocity must be at least 20 m/s [65 ft/sec].
The inside diameter of the hose connector is 75 mm [2.95 in].

4.4 Blade change

Sharp planing blades guarantee a proper planing result and put less strain on the motor. Therefore, replace or
turn blunt planing blades in time.
12
Caution
Health hazards from wood dust
The dusts produced during work can be inhaled and can cause health damage.
Harmful dust must be extracted with a HEPA 13 dust extractor.
➢
➢ Wear a dust mask during work.
Caution
Risk of injury from the tool
The blades on the planing shaft are sharp. You can hurt yourself when you work
on the tool.
➢ Wear protective gloves when you handle the tool.
Be careful when you handle the tool.
➢
ZH320 Ec
11/2021