Working Information - Mafell ZH320 Ec Instrucciones De Funcionamiento Y Seguridad

5.5 Working information

Prior to switching on the machine, position its base plate on the workpiece such that there is no contact yet
between the planing shaft and the workpiece.
Once the machine has reached its full rotational speed, hold the machine with both hands on the handles (2)
and guide it steadily over the workpiece. A steady feed results in a clean planing surface and is gentle on the
machine.
When working with full planing width, the guide roller (6) can serve as a lateral guide fence.
Use the following procedure for a lateral
guidance:
1. Release the knurled knob (5).
2. Swing down the guide roll (6).
3. Tighten the knurled knob (5).
4. Move the machine with the guide roll (6)
laterally against the workpiece and guide it
along the workpiece.
Lateral guidance active.
✓
Do not remove the machine from the workpiece with the planing shaft running.
The rotational speed of the planing shaft drops in case of overload.
Switch the machine off and back on. Wait until the planing shaft has reached its full
rotational speed again. Continue working then at a reduced feed rate.
At a chip removal 0, the switched-off machine can be put down on a flat surface without
damaging the support.
18
Fig. 13: Activating lateral guidance
ZH320 Ec
11/2021