Safety Clearances; Power Switch - LifeFitness ACTIVATE TREADMILL Instrucciones De Montaje

H P
OW TO OSITION AND
Follow all safety instructions. Move the treadmill to the location in which it will be used.
S C
AFETY LEARANCES
The following information is supplied as regional reference data regarding safety clearances around the exterior of the
treadmill.
• EU: The European EN957 Safety Standard requires a 6.5 ft. (2 m) minimum from the rear of the treadmill to any
object or surface and at least as wide as the treadmill.
• U.S. and other regions: The ASTM International (ASTM ) F2115 - 05 Standard recommends the minimum
dimensions to be 1.64 ft. (0.5 m) on each side of the treadmill and 3 ft. (1 m) behind the rearward most portion of
the usable moving surface or 6.5 ft. (2 m) behind the furthest rearward obstruction to emergency egress from the
treadmill.
After placing the unit where it will be used, check its stability. If there is even a slight rocking motion or the unit is not sta-
ble, determine which stabilizing leg is not resting on the floor. To adjust, loosen the JAM NUT (A), and turn the STABILIZ-
ING LEG (B) until the rocking motion ceases, and both stabilizing legs rest firmly on the floor. Retighten the JAM NUT.
Note: It is extremely important that the stabilizing leg be correctly adjusted for proper operation. An unbalanced unit may
cause striding belt misalignment. A bubble level is recommended to ensure proper leveling.
Note: Stabilize the treadmill each time the unit is relocated.
B
P S
OWER WITCH
Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions: "I" (one) for ON and "0"
(zero) for OFF.
6
S L F
TABILIZE THE IFE ITNESS
A
T
READMILL