Sauder 416091 Manual De Instrucciones página 19

Step 15
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the right diagram. If it isn't, loosen the
mounting screw to slide it against the stops. Then tighten the
mounting screw.
First, fasten the DOOR (J) with STRAIGHT HINGES (40H) to the RIGHT
å
UPRIGHT (C). Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
NOTE: Tighten the adjusting SCREWS completely in to center this DOOR
å
between the UPRIGHTS.
Fasten a DOOR (J) with CURVED HINGES (14H) to the RIGHT END (A). Use
å
the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten a KNOB (95K) to each DOOR (J). Use a BLACK 7/8"
å
MACHINE SCREW (37S).
Repeat this step for the remaining DOOR (J)
å
with CURVED HINGES (14H).
See the next step for additional
å
DOOR adjustments.
The curve of the KNOB can be
placed per your preference.
BLACK 7/8" MACHINE SCREW
(3 used for the KNOBS)
www.sauder.com/services
37S
Mounting
screw
C
Door with STRAIGHT
HINGES (40H)
416091
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Hinge
95K
95K
A
J
J
Door with CURVED
HINGES (14H)
Adjusting
screw
Page 19