Sauder 416091 Manual De Instrucciones página 7

Step 3
Turn eight BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
Slide the MOLDINGS (O and Q) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: The END MOLDINGS (O) are wider than the
å
UPPER END MOLDINGS (Q).
NOTE: Be sure to place the MOLDINGS in
å
the exact locations shown below.
Q
Edge with smaller holes
www.sauder.com/services
B
These edges
should be even.
BLACK 9/16" FLAT HEAD SCREW
Q
Edge with smaller holes
A
O
32S
(8 used in this step)
416091
These edges
should be even.
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
O
Page 7