Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Filling the Clean Water Tank
Open the clean water tank. Fill with water
until the Max line. Close the lid, lock the
latch, and fit the tank back in place.
Notes:
• To prevent corrosion or damage, only use the Roborock
branded floor cleaner in the water tank.
• To avoid water tank deformation, do not place hot water
in the tank.
• If water marks remain on the water tank, wipe them clean
before reinstallation.
On/Off
Press and hold the
button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
and hold the
button to turn off the robot
and complete the cleaning cycle.
Note:
The robot cannot be turned off when it is being
charged.
Starting Cleaning
Press the
button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room into
zones, first draws out zone edges, and then
fills the zone in a zigzag pattern. In so
doing, the robot cleans all zones one by
one, efficiently cleaning the house.
Zone 1 – Cleaned
Zone 2 – Cleaned
Zone 4 – Next Zone
Zone 3 – In Progress
Notes:
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
• Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting cleanup.
• If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
• Automatic mop washing will not work if the dock
encounters an error during cleaning. Wash the mop
manually to restore.
• When the mop mount is attached, the robot will retract it
when cleaning the carpet. You can also set the carpet as a
no-go zone in the app to avoid it.
• Before starting each mopping task, make sure that the
VibraRise mop has been properly installed.
Spot Cleaning
Press the
button to start spot cleaning.
Cleaning range: The robot cleans a 1.5 m
(4.9 ft) x 1.5 m (4.9 ft) square area centered
on itself.
09
Note:
After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Auto Mop Washing
During cleaning, the robot automatically
determines when it should return to dock
for mop washing and water tank refilling to
maximize its mopping performance.
Note:
To allow the robot to wash the mop automatically,
start the robot from the dock once it is fully charged. Do
not move the dock during cleaning.
Manually Activated Mop
Washing
During cleaning, press any button to pause,
then press and hold the
button to send
the robot back for mop washing.
Auto-Emptying
Auto-emptying will begin when the robot
returns to the dock after cleaning.
Notes:
• If the dock has not emptied for an extended period,
empty the robot dustbin manually and clear the air
inlet of any debris to ensure optimum performance.
• If necessary, auto-emptying can be disabled in the
app.
Manually Activated Emptying
Emptying can be triggered manually by
pressing the
button while the robot is
charging.
Note:
Avoid frequent manual emptying.
Publicidad
Tabla de contenido
