Roborock S7 Pro Ultra Manual Del Usuario página 11

Stopping Emptying
Press any button to stop emptying.
Pause
When the robot is running, press any
button to pause it, press the
resume cleaning, press the
send it back to the dock.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button
to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep mode
for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.
Child Lock
Press and hold the
disable the child lock. You can also set it in
the app. Once enabled, the robot will not
react to button presses when it is
button to
stationary. When the robot is cleaning or
button to
docking, press any button to stop it.
Charging
After cleaning, the robot will automatically
return to the dock to charge.
In Pause mode, press the
the robot back to the dock. The power
indicator will pulse as the robot charges.
Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs, the power indicator will
flash red and a voice alert will sound. See
"Errors" for solutions.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually will
end the current cleanup.
System Reset
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after
button to enable/
a system reset, switch it on. Press and hold
the
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot
will then be restored to factory settings.
App Features
Cleaning Map
• Multi-Map Management
• Real-Time Vacuum and Mop Route
button to send
• Carpet Display
• Map Zoning
• Map Editing
Custom Cleaning Modes
• Scheduled
• Selective Room
• Zone
• No-Go Zones and Invisible Wall
• Custom
• Carpet Boost
• Mop Wash Interval Settings
Cleaning Mode Switch
• Suction Power Levels
• Washing Intensity Levels
• Mop Washing Modes
• Custom Modes
Robot Information
• Cleaning History
• Battery Level
• Care & Maintenance
10
button and at the same time press