Safety Instructions Hazard Warnings - HOLZMANN MASCHINEN GBM25 Manual De Instrucciones

Icon image
12.4 Safety instructions
In order to avoid malfunctions, damage and health hazards when working with this machine, in
addition to the general rules for safe working, the following measures in particular must be
observed UNCONDITIONALLY:
 Choose a level, shaking-free, non-slip surface as a place to set up.
 Ensure sufficient lighting conditions in the workplace.
 Keep the workspace free of obstacles (e.g. metal chips, etc.).
 Clamp on the workpiece to avoid injuries from smashing around the workpiece.
 Never mount/demount the workpiece while machine is running.
 Don't get any clamping keys stuck in the drilling feed.
 Check the machine for its impeccable condition before each use.
 Never leave the running machine unattended.
 The machine may only be operated, maintained or repaired by persons who are familiar
with it and who are aware of the dangers arising from this work.
 Make sure that unauthorized persons maintain a corresponding safety distance from the
device, and in particular keep children away from the machine.
 Wear suitable work clothes (eye protection, hearing protection, safety shoes) as well as
tight fitting work protection clothing, never loose clothes, ties, jewellery, etc. – catchment
hazard!
 Tie long hair together or if necessary. Hide under a hair protection.
 Only clean the machine if the drill spindle is still standing.
 Refrain from working on the machine in case of tiredness, inconcentration or under the
influence of medication, alcohol or drugs!
 Do not use the machine in areas where vapours of paints, solvents or flammable liquids
pose a potential hazard (fire or explosion hazard!).
 Make sure the on-off switch is in the position "Aus " before turning on the machine.
 Make sure the device is grounded.
 Use only suitable extension cables.
 Always disconnect the device from the power grid before cleaning, maintenance or repair
work and secure it against accidental reactivation.
 Use only cutting tools in perfect condition.
12.5 Hazard Warnings
Despite intended use, certain residual risks remain. Due to the design and construction of the
machine, hazardous situations may occur which are identified as follows in these operating
instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
A self lockinging emergency switch to stop dangerous movements at
any time.
A height-adjustable drill feed protection equipped with a monitoring
switch.
T-grooves in the work table for fixing the workpiece or a vice.
D A N G E R
W A R N I N G
SAFETY
22
GBM25; GMB25T