BoomToneDJ BEE-FX LZR Manual De Instrucciones página 28

be secured with a safety sling. Also make sure that the structure (or hooking point)
can support at least 10X the weight of the hooked device.

The unit must be installed by a qualified person and must be placed out of reach of
the public.

Operating Premises: Whenever possible, a LASER should be operated in a room or area
reserved for that purpose, enclosed or delimited.

The accesses to the premises and their openings to the outside must not be located
in the axis of a direct beam.

The floor must be free of obstacles. Causes of accidental reflection and scattering of
laser beams must be eliminated (poorly placed windows, furniture or objects with
polished faces).

Paintings (walls, partitions, ceilings, etc.) and floor coverings should preferably be
matte. In this respect, diffuse reflections of class 4 lasers, focused beams of class 3
lasers with visible or near infrared light must be considered as dangerous and treated
as such.

When using powerful lasers (class 3 with focused beam or 4), it is necessary to
eliminate the possibility of the beam impacting on flammable materials (wood, paper,
fabrics or plastics) which can cause fires under power densities of the order of a few
W.cm-2 applied for a few seconds.

Access to laser emission areas must be marked using signs that comply with the
ministerial order of November 4, 1993 "Health and safety signs in the workplace" and
the NF X 08-003 standard "Graphic symbols and pictograms - colors and safety signs"
of December 1994. This signage is completed by the mention of the class of the laser
device and the instructions provided in standard NF EN 60825-1. These accesses can
be controlled, at least when lasers are in operation.

Emission control: the control panel should be placed outside of locations exposed to
hazardous emissions. The control of Class 3 and 4 lasers must be under the control of
a control key, removed when the device is not in use and held by a qualified person.
Warning:

The use of this device is exclusively reserved for professional entertainment and
display activities.

When in use, this device must be installed so that the rays remain above the eye
level of the public and do not reach them in any case.

It is forbidden to use this device for any purpose other than that for which it is
intended.

The manufacturer and distributor are not responsible for damage caused by LASER
BoomtoneDJ. The user is responsible for the use and compliance with the regulations NF
EN 60825-1:2014.
28