smartmi VortexWave Manual De Usuario página 21

Replacing the cleaning blade
Long press for 3 seconds. After the robot is powered off,
1
remove the water tank.
As shown in the figure, pull out the old cleaning blade from the cleaning blade unit opening. After confirming the installation
3
direction of the cleaning blade, replace the old cleaning blade with a new one. Install the cleaning blade unit back into the
robot and ensure that the screws fixing the unit in place have been securely tightened.
Cleaning blade
installation
Note: Check to ensure that the cleaning blade has been installed correctly. Reverse installation will affect the cleaning efficacy of the robot. It is recommended that
the cleaning blade be replaced every 6-12 months.
As shown in the figure, turn the robot over, use a screwdriver
2
to remove the 6 screws fixing the cleaning blade unit in
place, and then remove the cleaning blade unit.
Cleaning
blade unit
16