Publicidad
Idiomas disponibles
Idiomas disponibles
If other fan or supply wires are different color, have this unit installed by a qualified electrician.
d. Push all connected wires up into junction box.
e. Reinstall the canopy on the mounting bracket.
f. Restore the electrical power.
3. OPERATING TRANSMITTER:
A. H, M and L buttons: (Fig. D)
These three buttons are used to set the fan speed as follows:
H= high speed
M= medium speed
L= low speed
B.
button:
This button turns the fan off.
C. The "
" button:
The "
" button turns the light ON or OFF and also controls the brightness setting. Press and hold the button to dim and brighten the
light. Press and hold the button and release the button at desired brightness. The light key has an auto-resume, it will stay at the same
brightness as the last time it was turned off.
NOTE: The distance between the transmitter and receiver should not be greater than 30 feet. For best performance.
Fig.D
YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND LIGHT.
4. TROUBLESHOOTING GUIDE
A. Fails to operate:
a. Power to the receiver?
b. Receiver wired correctly?
c. Fan manual speed control in highest position?
d. Light kit switch turned on?
e. Code set at exact same position in both transmitter and receiver?
B. Won't operate at distance:
If transmitter operates the fan and the light kit when up close, but not a 30 feet
away, try placing the black antenna wire higher; up through the ceiling, outside the
junction box.
NOTICE!
Your ceiling fan and light kit assembly must meet
the following requirements:
1. Do not use with solid state fans.
2. Electrical rating: 120V / 60 Hz
MAX. motor amps:1.0 A
MAX. light watts: 250 W
(Incandescent only)
For Warranty Information please visit www.hinkley.com
.
Publicidad
