Erreka VIVO-D103 Manual Del Instalador página 50

Cuadro de maniobra para el accionador izar
Ocultar thumbs Ver también para VIVO-D103:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
Peripheral connections
ANT Antenna connector
R.E.
Plug-in receiver
STOP Emergency stop pushbutton (normally closed)
SMF Connector for traffic lights card
A.T. Opening/closing key device
In "dead man" mode, opening pushbutton
C.T.
Closing pushbutton
(in "dead man" mode only)
Check the accessory instructions to carry out
the connections with the control panel.
46
Installation Manual
R.E.
SMF Connector for lights signal card,
DEST Flashing light or siren connector
ANT Reception antenna connector
M.D. Reception board for remote-control
A.T. Control for opening and closing
C.H.P. Man Present closing control (65-ADB30HP10
only)
S.
Photocell contacts
STOP Pushbutton with locking (mushroom-head
halt button)
FCC
Closing limit switch
FCA Opening limit switch
AUX Power supply for peripherals (18-24Vac)
LG
Garage light (230V, 2300W max)
BAT Rechargeable battery terminals (12 Vcd, 1.2
Ah minimum)
SW1 General circuit breaker
SG
Safety device, contact normally closed
(photocell, mechanical strip)
AUX Output (24 Vac) for peripherals
BAT Rechargable emergency battery
(12V - 1.2Ah minimum)
DLG Garage light timer device
DEST Flashing light (230Vac, 60W max)
SW1 General circuit breaker
Key or button contacts (A.T.): do not directly
connect intercoms or similar devices which provide
an output with voltage. In these cases, use an
intermediate auxiliary relay and connect the NA
terminals of the said auxiliary relay to the control
panel.
P181Z

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Adb30

Tabla de contenido