Rating Plate; Operation And Handling; Before Initial Use; Preparation Of The Waterfilter - CASO DESIGN HW 1660 Manual De Instrucciones

-button: Set the desired temperature according to 000 (normal temperature water),
40°C, 50°C, 60°C, 70°C, 80°C, 90°C, 100°C.
-button: Set the water volume according to 100ml, 150ml, 200ml, 250ml, 300ml,
350ml, 400ml, 000 (continuous water flow)
-button: For setting of water hardness and start of cleaning and descale function.
-button: Press the button for about 3-5 seconds to unlock the device.
After approximately 15 seconds without operation it locks automatically. Press the button
again to unlock the device.
-button: Start and stop the dispense of water.

13.3 Rating plate

The rating plate with the connection and performance data can be found beneath the device.

14 Operation and Handling

This chapter provides you with important notices with regard to operating the device. Observe
the following notices to avoid dangers and damages.
► Do not leave the device unsupervised during operation.

14.1 Before initial use

14.1.1

Preparation of the waterfilter

1. Remove the waterfilter from all packaging.
2. Wash your hands and clean the water tank and the filter
holder.
3. Remove the water filter from its packaging and soak it in
fresh tap water for 10 minutes.
4. Rinse the filter for around 10 seconds under running
water.
5. Insert the filter into the filter holder, ensuring that it sits
firmly. To do this, push it down with a slight turning
movement, applying some pressure when doing so.
6. Insert the filter holder into the water tank. Run water
through the filter 2-3 times, using 1 litre each time,
before you drink the water.
Warning
36