Tabla de contenido
Publicidad
•
During use, always ensure the inlet and outlet grilles are not blocked in any way as this
will cause the unit to automatically stop. If this should occur, switch off and allow the
unit to cool.
•
Keep the power plug and cord away from heated surfaces.
•
Do not leave the appliance unattended while plugged in.
•
Do not place the appliance on any soft furnishings.
•
Do not use attachments other than those we supply.
•
Do not set the appliance down while still on.
•
Do not twist or kink the cable, or wrap it round the appliance.
•
Do not use the appliance if it is damaged or malfunctions.
•
Check the cord regularly for any sign damage.
•
This appliance is not intended for commercial or salon use.
PARTS
1. Rotation switch
2. Speed/heat selector switch (f, N, O)
3. 1000W power handle
4. Removable inlet grille
5. Swivel cord
6. hang up loop
INSTRUCTIONS FOR USE
Prepare the hair for styling
•
Wash and condition the hair as normal.
•
Squeeze out excess moisture with a towel and comb through.
•
Using the pre-styling nozzle rough dry the length and roots until 80% dry.
•
Divide the hair into sections, style the lower layers first.
To fit/remove attachments
Fit the attachment before you turn on the appliance.
CAUTION: Attachments can become hot during use, let them cool before removing.
1
To remove, twist the attachment until the markings line up as shown in figure A and pull
it off the power handle.
2
To fit an attachment, align the symbols on the power handle and attachment as shown
in figure B then twist the attachment until it locks into place.
Speed and temperature settings
1
Plug your styler in to the mains power supply.
2
Turn your air styler on and select the appropriate setting for your hair by sliding the
speed/heat selector switch.
3
Your air styler has three settings:
7. 40 mm soft bristle brush
8. Firm paddle brush
9. Pre-styling nozzle
Not shown:
•
Protective cover
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE
5
Publicidad
Tabla de contenido
