Makita CW002G Manual De Instrucciones página 10

4. Selecting the control temperature
Press the temperature setting button to select
the control temperature. Refer the chapter
"SPECIFICATIONS" for the selectable control
temperature.
The appliance starts cooling / heating 5 seconds after
without any operation, then the control temperature stop
flashing and the temperature display shows the current
temperature.
The appliance stops cooling / heating when the current
temperature reaches the control temperature.
Tips for efficient cooling / heating
• Opening the upper cover for long periods can
cause significant increase / decrease of the
temperature in the chamber.
• Regularly clean surfaces that can come in contact
with food and accessible drainage systems.
• Store raw meat and fish in suitable containers in
the chamber, so that it is not in contact with or drip
onto other food.
• If the chamber is left empty for long periods:
- Switch off the appliance.
- Defrost the chamber.
- Clean and dry the chamber.
- Leave the upper cover open to prevent mould
developing within the chamber.
FUNCTION
Indicating the remaining battery
capacity
The battery indicator shows the remaining battery
capacity. The remaining battery capacity is shown as
the following table.
Battery indicator status
Lighted
(Blinking)
Remaining
capacity
Off
50 % to 100 %
20 % to 50 %
0 % to 20 %
Charge the
battery.
(Only for battery cartridges with the
indicator)
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for a few seconds.
► Fig.3 1. Indicator lamps
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Appliance / battery protection
system
The appliance is equipped with the protection
system. This system automatically cuts off power to
extend appliance and battery life. The appliance will
automatically stop during operation if the appliance or
battery is placed under one of the following conditions.
• Battery overdischarge protection
When the battery capacity becomes low, the
appliance stops automatically. The battery
indicator prompts that the battery should be
charged. Remove the batteries from the appliance
and charge the batteries.
• Overcurrent protection
When the appliance / battery is operated in a
manner that causes it to draw an abnormally high
current, the appliance automatically stops. In this
situation, stop the application that caused the
appliance to become overloaded. Then turn the
appliance on to restart.
• Low-voltage protection
When the car input voltage is lower than the
rated voltage, this protection system turns off the
appliance and the temperature display shows "F3"
with beep sound.
10 ENGLISH
2. Check button
Off Blinking
75 % to 100 %
malfunctioned.
Remaining
capacity
50 % to 75 %
25 % to 50 %
0 % to 25 %
Charge the
battery.
The battery
may have