10.3 Unpacking the appliance
If you open the packaging imprudently
with a sharp knife or other pointed
object, the coffee maker can be
damaged.
After removing the packaging check that
all components and accessories were
delivered. In case of doubt do not use
your appliance and contact a qualified
technician.
Take the appliance out of the
packaging.
Examine the delivery for
completeness.
If the delivery is incomplete or
damaged, contact customer service.
See the service address
Remove all protective films.
10.4 Electrical connection
WARNING
Electric shock due to a faulty connection
The appliance must be switched off
when it is being attaching to the
electricity mains.
The switch must be at 0.
•
Examine the mains voltage with the
information on the identification
plate.
You will find the information
o
for this on the identification
plate on the appliance.
•
Connect the appliance only to a
shockproof socket, which has been
installed in accordance with the
provisions.
11 Initial operation
Clean the appliance with a damp cloth
before first starting it up.
Setting the coffee machine up
•
Set the appliance on a level, stable
surface.
•
Insert the mains plug into a socket with
safety contacts.
Before brewing coffee for the first time
www.ggv-service.de
2
Seite | 14
EN
•
2
Let it run through the cycle twice only
with clean water and without paper
filters in order to remove dust that may
have accumulated during production.
Do not use coffee powders for this
cleaning run under any circumstances.
12 Operation
To operate the appliance, proceed as
follows:
Open the water tank cover
Based on the desired number of
cups, pour cold water into the
water tank.
water level from the scale.
CAUTION
Fill the water tank with water up to the
MAX indication.
Make sure that the filter holder is
inserted.
Bend the lower crease of the paper
filter (size 1x4)
Set the filter into the filter holder.
Fill the filter with the desired
quantity of coffee powder
Close the filter lid.
Place the pot on the hotplate.
Switch the appliance on. The control
light in the switch will come on.
IMPORTANT
The brewing process lasts approx. 8-12
minutes.
13 Decalcification and
cleaning
Decalcification becomes necessary if
preparation time increases substantially.
Use only commercially available
•
decalcifying agents based on citric
acid.
Use the portions indicated on the
•
packaging or on enclosed leaflets.
You can read the