Operating Instructions - Kobalt KCH 2411-03 Manual De Instrucciones

OPERATING INSTRUCTIONS

1. To Charge a Battery Pack
NOTICE: Battery packs are
shipped in a low charge
condition to prevent possible
problems. Before using it the
first time, fully charge the
battery pack.
a. Make sure that the battery
pack is compatible with
this charger.
b. Connect the charger to a
power supply. The LED
charge indicator (B) will shine red for 0.5 second first, then shine
green for 0.5 second, and then go out, indicating that the charger
self-inspection is completed.
c. Attach the battery pack to the charger by aligning the raised ribs
of the battery pack with the slot in the charger. Slide the battery
pack onto the charger (Fig. 1).
d. The charger will communicate with the battery pack's circuitry
to evaluate the condition of the battery pack. Please refer to the
"Charger Display" section.
e. The LED charge indicator (B) will flash green continuously during
normal charging.
f. After charging is complete, the indicator (B) on the charger will
shine green, without flashing. The power indicator LEDs on
the battery pack will turn off. The power indicator LEDs on the
battery pack will illuminate when the power indicator button is
pressed when the battery pack is detached from the charger.
NOTICE:
• When the battery pack is fully charge, disconnect it from the charger.
1
B
11
A