Time Setting; Alarm Setting - MOB MO9091 Manual Del Usuario

common display mode.
On Default.
24H display time 00:00, barometer unit HPA, temperature unit C

3.1 Time Setting

• In time mode, press and hold "MODE" for some seconds to enter setting in sequence:
Hour → Minute → Year → Month → Day → Week Language → Exit
Setting item twinkling at 1Hz frequency.
• Press "UP" key, the data goes ahead one step; press and hold for 2 seconds, goes ahead
at 8 steps/second speed.
• Press "DOWN" key, the value go back one step; press and hold for 2 seconds, go back at
an 8 step/second speed.
• After setting, press "MODE" to exit.
• If no key is pressed for 10 seconds the time mode will be leaved. The current setting will be
saved.

3.2 Alarm Setting

• In normal mode, press "MODE", switch to AL1 or AL2 display:
AL1 default time 6:00am, AL2 default time 0:00am
• In AL1 Mode, press and hold "MODE" for some seconds to enter AL1 setting.
• Setting in sequence: AL1 Hour → AL1 Minute → Exit
• Setting item twinkling at 1HZ frequency.
• Press "UP" key, the value goes ahead one step; press and hold for 2 seconds, go ahead at
an 8 step/second speed.
• Press "DOWN" once and back; press and hold for 2 seconds, go back at an 8 step/second
speed.
• After setting, press "MODE" to confirm and exit.
• If no key is pressed for 10 seconds the alarm mode will be leaved. The current setting will
be saved.
• AL2 Setting is the same as AL1 setting.
3.3 Alarm ON/OFF
• In time mode, press "ALARM" to turn on/off the alarm in sequence: AL1 ON→AL2 ON→AL1
and AL2 ON→AL1 and AL2 OFF
• When alarm is turn on and when time is up, it alarms, during alarming, press
"SNOOZE/LIGHT" key to turn on snooze,
the time; press any other key to stop the alarm and exit the alarm.
• No any key pressed, alarm stops automatically after 2 minutes.
• During alarming, corresponding AL character twinkling on the display.
• In snooze mode, corresponding AL character and Snooze symbol twinkling display. Press
"SNOOZE/LIGHT" to turn on backlight for 8 seconds, press any other key to stop and exit,
at the same the alarm is off.
• When alarm or snooze working, in case of RCC receiving time is out, RCC receiving would
be put off until the alarm or snooze finished.
• If alarm time is same for both AL1 and AL2, only AL1 symbol twinkling on display when time
is up.
• When one alarm time or snooze time is out, during alarming, it happens to meet another
alarm, then the first alarm would stop and work out new alarm.
• Snooze could be repeated all the time.
• BUZZER for 2 minutes in alarm format.
1. 0-10 second: BI per second.
2. 10-20 second: BIBI per second.
3. Over 20 seconds: BIBIBIBI per second.
3.4 Snooze interval setting
• In normal mode, press "SNOOZE/LIGHT" key for some seconds to enter snooze interval
time setting (optional from 3 minutes to 20 minutes, default: 5 minutes)
• Setting snooze item twinkling at 1HZ frequency
o
symbol and corresponding alarm twinkling all
- 3 -