Before Use; During Use; Before First Use; Intended Use - Batavia BT-CCT001 Manual De Usuario

• Use the appliance only with the type of
battery indicated in the instructions.
Using another type of battery can cre-
ate a serious risk of injury and cause a
fire.
• When the battery is not in use, keep it
away from metal objects such as trom-
bones, coins, keys or other small metal
objects that can create a connection
between one terminal and the other.
Short-circuiting the terminals of batter-
ies can cause burns to the user and
cause a fire.
• Always keep the cord away from the
moving parts of the machine.
• In the case of locking, switch the
machine off immediately and remove
the plug from the mains.
• Compare the maximum number of
revolutions allowed of the accessories
with the number of revolutions of the
machine.
• When you put the machine away the
engine must be switched off and mov-
ing parts must have reached a
standstill.
• Never attach an assembly spanner to
your machine with a piece of string or
anything similar. Never use the axle
locking button if the machine is
operating.
• Make sure that the spring chuck diame-
ter is the same as the axle diameter of
the accessory.
• Use a clamping device for securing the
work piece.
• Keep your hands away from the work
piece.

4. Before use

• Remove any packing material and loose
parts from unit.
• Check the accessories before use. It
should be fit with the machine and your
purpose.
• If the machine is new, the battery must
first be charged.
• Battery is housed in the handle, press
the battery retention clips, and remove
battery from handle.
• A substantial drop in operating period
per charge indicates that the battery is
worn out and must be replaced.
Attention! After long time storage, the bat-
tery capacity will be reduce.
Battery charger
• The power voltage supply must con-
form to that specified on the rating
plate of the rapid charger.
• Always inspect battery charger, cord
and plug before use.
• Always have damage repaired by a
qualified professional.
• Protect battery charger against humid-
ity and operate only in dry areas.
• The supplied charger is suitable for
charging batteries only.

5. During use

• Hold power tool by insulated gripping
surfaces, when performing an opera-
tion where the cutting accessory or
fastener may contact hidden wiring
(cutting accessory and fasteners con-
tacting a "live" wire may make exposed
metal parts of the power tool "live" and
could give the operator an electric
shock).
• In case of electrical or mechanical mal-
function, immediately switch off the
tool or unplug charger from power
source.

6. Before first use

Remove any packing material and loose
parts from unit. Check the accessories
before use. It should be fit with the machine
and your purpose. If the machine is new, the
battery must first be charged.

7. Intended use

The machine is intended for drilling, grind-
ing, polishing, milling and brushing and
other jobs like engraving, cutting and
removing rust are also possible

8. Operation

Chuck
8.1
a. Press spindle lock button (2) and rotate
the spindle by wrench (15) until the lock
English
7