Programming The Guest Mode; Taking Weight Measurement Only - Tanita UM-040 Manual De Instrucciones

Take a Reading
After programming your personal data you are ready to take a reading.
Select Personal Data Number
Press the "Up" arrow button to turn the unit on.
Press the "Up/Down" arrow buttons to select personal data number.
Press the set button.
The unit will beep and the display will show "0.0".
Now step onto the platform.
Get Your Readings
Your weight will be shown first. Continue to stand on the platform.
"00000" will appear on the display and disappear one by one from left to right.
The readings will be shown alternately 3 times as follows:
Weight Body fat percentage Total body water percentage
Note: Do not step off until "00000" disappears.
Recall Function (UM-041 only)
To obtain previous readings, press the SET button while the current readings are being displayed.
Press the SET button again to go back to the current Weight and Body Fat % result display.

PROGRAMMING THE GUEST MODE

Guest Mode
Guest mode allows you to programme the unit for a one-time use without resetting a Personal data number.
Press the Down button to activate the unit. Then follow the steps: Set Age, Select Female or Male, and Specify Height.

TAKING WEIGHT MEASUREMENT ONLY

Select Weight-Only Mode
Tap the Weight-Only key to select Weight only mode.
7