StetSom SX2 Manual De Usuario página 3

Resources
• Command up to 16 functions;
• Synchronization with up to 16 controls (TX2) allowing multiple people to
control the same equipment.
• The TX2 control can command several devices even though different
brands.
• Easy Sync. No need for technical assistance when purchasing new remote
controls units.
• It Contains various models of appliances in memory beyond the "Learn"
function that enables programmatic control of the market.
• Low battery indicator on the control and central.
Installing Your Alcance Control
The control panel can be installed or hidden somewhere visible for
monitoring your LED indicator (16). The most important is that your antenna
(15) is not blocked by the bodywork of the car or metal parts which act as
a shield for radio transmission frequency. It may be close to the edge of the
window since glass does not block the reception or in the panel and drawers.
The power cable (18) is biased. The route that has white stripe should be
connected to positive and black to negative way. Power can be an automotive
battery, 9V or a USB.
The Red (17) Infra transmitter must be fixed at some point pointing to the
panel of the equipment to be controlled, make sure that nothing is between
the two.
4
The second key feature "2nd"
The Alcance Control SX2 has a great market differentiator, can control up to
16 different functions. Each one of the 8 TX2 Control keys can perform two
functions, for a total of 16. The 2nd key is to select what function each button
will run, first or second.
Pressing the 2nd Led (01) button lights indicating that the second function is
active, pressing again it goes back to the first function keys. The second function
remains active for 5 seconds, after that time the LED switches off automatically
returning to first function.
Example: + key when the first function (LED indicator (01) deleted) increases the
volume of the equipment, the second function acts as ENTER key widely used in
DVD equipment. The Play/Pause button has the second function MENU.
The Printed functions on each TX2 control button are related to be function of
each unit, and are stored in the memory of the central RX2. Nothing prevents
these buttons from being reprogramed to perform different functions, by the
learn mode.
Synchronizing Your Alcance Control
Timing is necessary for the connection between the central control TX2 and RX2.
The Alcance Control is synchronized by the factory. This operation is required
only if the owner acquired new TX2 controls for your team, replacement or
loss of synchronization. The Alcance Control allows up to 16 TX2 controls are
synchronized in the same central RX2.
5