Learning Mode - StetSom SX2 Manual De Usuario

Ocultar thumbs Ver también para SX2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Programming
For the operation of your Alcance Control, the central RX2 should be
scheduled for the model of your device. This can be done in two ways, Direct
Mode (using the models of handsets from memory) or Learning Mode.
Direct Mode:
1. Look for the code of your machine in Code Table "Memory " (See page X).
2. Press the LRN key (21) in the central RX2. The LED indicator (16) will flash.
3. Press the SYNC key (20) in the central RX2. The LED indicator (16) will
flash faster.
4. Press in the TX2 control the first key of the table, the LED indicator (16)
will erase for a moment and return to rapid flashing.
5. Press the second key of the table. The LED indicator (16) will delete.
Its central is programming for the chosen device.
Example: Programming for Player PIONNER
CD/MP3-Player
DEH-8380SD
2
3
8
Keys Sequence
4
Programming
Note: Choose a dimly lit environment, prefer location without fluorescent
lamp or in a car, because external light may interfere with the Receiver
Infrared (19) Central. Plasma screens are also strong sources of interference.

Learning Mode:

1. Press the central RX2 LRN key (21). The LED indicator (16) will flash.
2. Press the control button TX2 you want to store. The LED indicator (16) will
erase for a moment and light. For Second function, first press the 2nd key
and then the desired key.
3. Point the original remote of the device you want to copy to the central
RX2 Receiver Infrared (19) and press the key to be stored. The LED indicator
(16) will erase for a moment and re-flashing the recording of this key is
completed.
Note: At this stage interference of external light can occur. If this
occurs, the control panel will detect the failure and rapid blinking the
LED indicator (16) instead of deleting and then will erase for a moment
and return to step 2 with LED indicator (16) flashing.
4. Repeat steps 2 and 3 for all the buttons you want to program. If a key is
programmed wrong, repeat steps 2 and 3 as many times as necessary.
5. To exit Learn Mode press the LRN key (21) the central RX2.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido