StetSom SX2 Manual De Usuario página 4

Synchronizing Your Alcance Control
Attention: Before performing the timing make sure that there is no one
other TX2 central control being operated near you, because it may interfere.
Follow the Steps Below to Synchronize:
1. Press the SYNC key (20) the central RX2. The LED indicator (16) will flash.
2. Press one of the TX2 control except Power button (2).
3. The LED indicator (16) stops flashing. Timing is completed.
1
To synchronize more than one control (maximum 16), repeat steps 1-3. If
more than 16 controls are being synchronized, this new control will override
the first synchronized canceling your timing and so on.
It is also possible to undo the timing control of each or all at the same time.
Undoing the Timing of a Single Control
1. Press the SYNC key (20) the central RX2. The LED indicator (16) will flash.
2. Press the Power button (2) or 2nd and Power TX2 control you want to
delete.
3. The LED indicator (16) stops flashing. The exclusion is complete.
6
2
Undoing the Timing of a Single Control
Note: When a control is deleted it releases one of 16 internal memories, if a
new control to synchronize the operation will not delete any of the controls
stored as a memory has been released.
1
Undoing the timing of all controls
1. Press the SYNC key (20) of the central RX2. The LED indicator (16) will
flash.
2. Press the LRN key (21) of the central RX2. The LED indicator (16) will flash
faster and delete. The exclusion is completed.
1
2
2
7