Component List - Worx WX709 Manual Original

wheel increases the loading and susceptibility to
twisting or binding of the wheel in the cut and the
possibility of kickback or wheel breakage.
b) Do not position your body in line with and
behind the rotating wheel. When the wheel,
at the point of operation, is moving away from
your body, the possible kickback may propel the
spinning wheel and the power tool directly at you.
c) When wheel is binding or when interrupting
a cut for any reason, switch off the power
tool and hold the power tool motionless until
the wheel comes to a complete stop. Never
attempt to remove the cut-off wheel from the
cut while the wheel is in motion otherwise
kickback may occur. Investigate and take
corrective action to eliminate the cause of wheel
binding.
d) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully reenter the cut. The wheel may bind,
walk up or kickback if the power tool is restarted in
the workpiece.
e) Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
10
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
ADDITIONAL SAFETY RULES
FOR ANGLE GRINDER
WARNING:
locked position before start the angle grinder.
Rotating the handle is permitted only in the switched
off condition.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Angle Grinder
Make sure the handle in the
Wear ear protection
Wear eye protection
Wear dust mask
Wear protective gloves.
Make sure the tool is unplugged prior to
changing accessories.
Lock
Unlock
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or
retailer for recycling advice.

2. COMPONENT LIST

1. AUXILIARY HANDLE
2. ROTARY BUTTON
3. ON/OFF SWITCH
4. LOCK-OFF BUTTON
5. BRUSH COVER
6. WHEEL GUARD FOR GRINDING
7. DISC *
8. SPINDLE LOCK BUTTON
9. SPANNER
10. INNER FLANGE
11. OUTER FLANGE
12. WHEEL GUARD FOR CUTTING
EN