GB
Contents
Safety .................................................. 2
Safety
1. Take care that all the guards
are in correct position and fixed
during operation.
2. Always stop the machine prior to
greasing, adjusting or repair.
3. Blower noise can be irritating.
Ear protection should be used
under long-term continuous
exposure.
First Start-up
Instructions
1. All wiring must be made by a
certified electrician.
Min. fuse at 3 x 380 V
(recommended):
SUC 100E: 25 Amp.
SUC 150E: 35 Amp.
SUC 200E: 35 Amp.
SUC 300E: 63 Amp.
SUC 500E: 100 Amp.
2
4. Use eye protection when work-
ing in the vicinity of the intake
nozzle. Kernels can fly out of the
secondary air opening, causing
eye damage if proper protection
is not worn.
5. Avoid open suction pipes.
Clothing or objects can be
drawn into the machine and
cause injury to a person or
damage to the machine.
2. Make sure that the direction of
rotation of blower and rotary
valve is correct (see arrows on
blower and rotary valve).
3. Check that the belt tension is
correct.
4. Make sure that all bolts are
tightened. Retighten the bolts
after the first day of operation.
6. After conveying treated grain the
machine and the pipe system
should be carefully cleaned out.
7. Always use a discharge cyclone
to decelerate the grain and to
separate it from the air stream.
8. The conveying air is heated
while it passes through the
blower, hence the blower hous-
ing may be hot (over 100°C).
Care must be taken when touch-
ing the blower.