Ducati Pro-I Evo DU-MO-210001 Manual Del Usuario página 9

Model Reference picture
Pro-III
Method:
• Take the item out of the packaging
• Open the kickstand and check that the item is stable
• Open the handlebar stem and secure it by closing the lever of the closing mechanism
• Connect the display power cable to the main wiring (if necessary)
• Install the handlebar on the stem (do not crush the cables)
• Tighten the screws on the stem using the wrench supplied
• Adjust the stem closing mechanism*
In the package
Accessories:
- Allen wrenches
- Components for handlebar
assembly (hook, plastic
parts, 3 screws)
- Tyre inflation adapter
- Charger
- 2 RF Keys for scooter
ignition
08
Handlebar assembly
Method:
1. Open the kickstand
2. Pick up the handlebar, place
the lever in the closed position
and lower the safety ring.
3. Install the handlebar on
the shaft
4. Install the hook (see photo)
by approaching it to the rod,
making sure that it is aligned
with the holes, then insert
the screws.
5. Insert the screw on the
outside into the hole located
under the control panel.
6. Tighten the screws.