Uline H-9884 Manual página 3

CALIBRATION
1. Press and hold MENU-CAL until MENU is displayed.
When button is released, the display will show CAL.
2. Press YES to accept; SPAN will be shown. Press YES
again to begin span calibration.
3. - -C-- will blink while zero reading is stored. The
display will show the calibration weight value. Place
the specified weight value on the pan. --C-- will
blink while the reading is stored.
4. The scale will return to the previous application
mode and is ready for use.
WEIGH MODE
1. Press and hold MODE until WEIGH is displayed.
2. If required, place an empty container on the pan
and press TARE.
3. Add material to the pan or container. The display
will show the weight of the material.
PARTS COUNTING MODE
NOTE: This mode counts large numbers of items
based on the weight of a reference count.
1. Place an empty container on the pan and press
TARE.
2. Press and hold MODE until COUNT is displayed.
CLr.APU (Clear Average Piece Weight) will then
display.
3. Press NO to use the stored Average Piece Weight
(APW) or press YES to establish a new APW.
NOTE: If choosing NO to use stored APW, skip
to step 6.
NOTE: If choosing YES to set a new APW,
continue to step 4.
NOTE: Press FUNCTION to view the current APW.
NOTE: To clear the stored APW, press and hold
MODE until COUNT is displayed. Press YES when
CLr.APU is displayed.
4. After pressing yes, the scale will then display the
stored sample size. Press NO or BACK to toggle the
choices 5, 10, 20, 50 or 100.
5. Put the indicated number of pieces on the pan.
Press YES to calculate the APW. The display will show
the piece count.
6. Add additional pieces until the desired count is
reached.
PAGE 3 OF 24
OPERATION
CHECKWEIGH MODE
NOTE: This mode sets low and high weight limits
for portion control processes.
1. Press and hold MODE until CHECK is displayed.
CLr.rEF (Clear References) will then display.
2. Press NO to use the stored reference weight limits or
press YES to establish new reference values.
(Skip to step 5)
NOTE: If choosing NO to use stored reference
weight limits, skip to step 5.
NOTE: If choosing YES to set new reference
weight limits, continue to step 3.
NOTE: Press FUNCTION to view low and high
reference weight limits.
To clear the stored reference values, press and
hold MODE until CHECK is displayed. Press YES
when CLr.rEF is displayed.
3. The balance will then display SET. Lo. Press YES to
view the "Low" limit value. Press YES to accept or NO
to edit the "Low" limit value. The stored value displays
with the first digit highlighted 000.000 kg. Repeatedly
press NO until the desired number appears. Press
YES to accept and highlight the next digit. Repeat
until all the digits are correct. Press YES to accept
the "Low" limit value; SET. HI will be displayed.
4. Repeat steps 1-3 to accept or edit the "High" value.
5. Place sample material on the pan. The "Accept"
indicator will show that the sample weight is within
the acceptable range.
0422 IH-9884