Changing The Parameters - Behringer ODYSSEY Guia De Inicio Rapido

90
ODYSSEY
ODYSSEY Parameter Set

CHANGING THE PARAMETERS

The parameters may be changed using the following procedures:
1. Press SHIFT+ HOLD/REST + 8 to enter the setting mode. The LOCATION LED 1 will blink yellow.
2. Press <KYBD or STEP> to select pages 1, 2, or 3. The yellow LOCATION LED, shows the current page:
3. Page 1 allows you to select the MIDI input channel, 1 to 16.
4. Page 2 allows you to select the MIDI output channel, 1 to 16.
5. Page 3 allows you to select the clock source, from 1 to 4 (INTERNAL/ MIDI DIN/ MIDI USB/ AUTO). When AUTO is used, the clock priority is:
MIDI USB > MIDI DIN > INTERNAL.
6. Press STEP switches 1 to 8 to select numeric values from 1 to 8. The current value is indicated by a green LOCATION LED.
7. To access values 9 to 16, press SHIFT + STEP switch 1 to 8. The current value is shown by a red LOCATION LED.
Note: If a setting is on the same LED number as the current page LED, then the LED will flash alternately between the yellow page color and the green or
red parameter color.
8. Press SHIFT + HOLD/REST + 8 to exit the setting mode, and save any parameter changes.
9. More parameters can be changed using the Synthtool App.
ADSR Envelope
The stages of the ADSR envelope are shown in this simplified diagram below. The envelope can control the
VCA level, or the VCF cut-off frequency, and FM and Pulse Width modulation of VCO-1 and VCO-2.
Attack Decay
Time Time
Env
Level
Sustain Level
Key
Gate
Key Pressed
Release
Time
Time
Key Released