Makita GCU01 Manual De Instrucciones página 13

Adjusting the chain lubrication
You can adjust the oil pump feed rate with the
adjusting screw using the universal wrench. The
amount of oil can be adjusted in 3 steps. Open
the cap to adjust the adjusting screw.
Fig.8
► 1. Cap 2. Adjusting screw
Carabiner (rope attachment point)
You can hang the tool by attaching the rope to
the carabiner. Pull up the carabiner, and then tie
it with the rope.
Fig.9
► 1. Carabiner
Spike bumper
The tool is equipped with the spike bumper as
standard. For replacement of the spike bumper,
ask Makita Authorized Service Centers.
When you perform the cutting operation, engage
the spike bumper with the trunk and use it as a
lever.
1
2
1
Electronic function
The tool is equipped with the electronic functions
for easy operation.
• Electric brake
This tool is equipped with an electric brake.
If the tool consistently fails to quickly stop
after the switch trigger is released, have the
tool serviced at a Makita service center.
ASSEMBLY
CAUTION: Always be sure that the tool
is switched off and the battery cartridge is
removed before carrying out any work on
the tool.
CAUTION: Do not touch the saw chain
with bare hands. Always wear gloves when
handling the saw chain.
Installing or removing saw chain
CAUTION: The saw chain and the guide
bar are still hot just after the operation. Let
them cool down enough before carrying out
any work on the tool.
CAUTION: Carry out the procedure of
installing or removing saw chain in a clean
place free from sawdust and the like.
Installing the saw chain
To install the saw chain, perform the following
steps:
1.
Release the chain brake by pulling the front
hand guard.
2.
Loosen the chain adjusting screw, then the
retaining nut.
Fig.10
► 1. Sprocket cover 2. Chain adjusting screw
3. Retaining nut
13 ENGLISH
1 2 3