UFESA FLEXY-HEAT CIE Manual De Instrucciones página 18

the automatic shutdown included in the product. In the event of continued use, the
temperature controls should be set to their minimum level of operation (level 1).
Materials will suffer wear and tear over time and after prolonged use.
Unplug the product immediately from the mains in the event of any breakdown and contact
an authorised Technical support service.
In order to prevent any risk of danger, do not open the control or connection. Only qualified
technical personnel from the brand´s Official Technical support service may carry out
repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and
void. Only an authorised technical support service centre may carry out repairs on this
product.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
Completely stretch out the electric blanket over the mattress, leaving a space free at the
top, to place the pillow, fitting the elastic straps of the electric blanket to the mattress,
and then place it under the sheet. Prevent any wrinkles, folds or creases and ensure that
the outlet is at the top of the bed. (See figure 1).
Then proceed to make the bed in the usual way.
Avoid placing any bags or other heavy objects on the bed while the electric blanket is
turned on as well as its use at the same time as other sources of heat such as hot water
bottles, heating pads or similar products.
In order to prolong the shelf life of your product, make sure that the regulator control
switch is in the "0"position before connecting or disconnecting it from the mains.
In order to turn on the product, you must select the slider switch on the control, setting it
to position 1, 2 or 3 (Fig.2).
The maximum operation time is 3 hours, after which the automatic safety shut-down will
immediately activate. The product will no longer heat up when in this state.
To turn on the product again, set it to position "0" and select the desired temperature.
Select the "0" position in order to turn off the product before you disconnect the device
from the mains.
This electric blanket comes with rapid heating technology, which enables the heat to be felt
just 15 minutes after turning on the control knob, regardless of the selected temperature.
Set the temperature to a lower level after this time.
The control should be set to its minimum temperature (level 1) when using the product for
extended periods of time. Try to avoid excessive exposure to heat from high temperatures.
The highest control temperature level (level 3) should be used only for the time necessary
to obtain a comfortable temperature, and the temperature should be gradually lowered to
a lower position after this threshold has been reached.
18