Dimplex LVA231 Manual De Instrucciones página 7

Manual Control Operation
The manual controls are located on top of the appliance behind the
glass screen (see detail view 'Y' in Fig. 4).
For description of manual button settings see below:
Standby Switch 'On'
Audio volume 'Down'
Audio volume 'Up'
Scene selection 'Up'
Scene selection 'Down'
The manual Heat On/Off switch is located at the lower right side of the
appliance on Model LVA231 and at the lower left hand side of Model
LVA232 (see '4' in detail B in Fig. 1).
Remote Control Operation
The remote control may be operated once the appliance is switched
'ON'. Select any one of eight scenes on your remote control - see
Fig. 7.
Each scene has it's own particular sound effect which may be activated
and adjusted by pressing the audio volume control buttons (
to the level required, while aiming the remote control at the IR sensors
(see 'a' and 'b' in detail A in Fig. 1).
See below for button settings on remote control for various scene
selections:
'Coal' Fire scene
'Log' Fire scene
'Embers' Fire scene
'Spring' scene
'Summer' scene
'Autumn' scene
'Winter' scene
'Aquarium' scene
The heat may be switched On by pressing
indicated by red LED (see 'y' in detail A in Fig. 1).
The heat may be turned Off by pressing
The appliance may be switched into Standby mode by pressing the
Standby On/Off button (see 'x' in detail A in Fig. 1). Switching the
appliance back On using the Standby button will return to the scene
that was on the screen before turning it off. Alternatively any scene
selected may be switched on.
Note: When the appliance is switched into Standby mode the heat will
automatically be turned off, and if required when the appliance is
switched On again it must be independently switched on remotely or
manually as outlined in 'Operation'.
Note: The user may notice a slight frame freeze lasting less than
0.5 seconds after a scene has run for approximately 5 minutes.
This is normal and should not be a cause for concern.
The user has an option of turning heat On in Standby mode without
having a scene selected.
/ 'Off'
and
button Heat 'On' is
button.
- 2 -
Remote Control Assembly
Note: The remote control is packed separately in the carton.
1. Slide open the battery cover on the back of the remote
transmitter.
2. Install the AAA batteries into the remote control (see Fig. 5).
3. Replace battery cover.
Discard Leaking Batteries
Dispose of batteries in the proper manner according to Provincial and
local regulations. Any battery may leak electrolyte if mixed with a
different battery type, if inserted incorrectly, if all the batteries are not
replaced at the same time, if disposed of in a fire or if an attempt is
made to charge a battery not intended to be
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE APPLIANCE.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
Recycling
For electrical products sold within the European Community.
At the end of the electrical product's useful life it should
not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
)
After Sales Service
Should you require after sales service or should you need to purchase
any spares, please contact the retailer from whom the appliance was
purchased or contact the service number relevant to your country on
the warranty card.
Please do not return a faulty product to us in the first instance as this
may result in loss or damage and delay in providing you with a
satisfactory service.
Please retain your receipt as proof of purchase.
UK
recharged.