Mounting The Saw Blades; Recycling; Warranty - Carat SL-1502 Manual

12. MOUNTING THE SAW BLADES


Remove the 3 bolts in the blade guard

Take of the outer part of the blade guard

Loosen centre bolt in the saw shaft, by blocking the shaft
with the alan-key.

(Re)place the saw blades on the preferred width by using
the rings.

Fasten centre bolt in saw shaft (with alan key)

Replace outer part of blade guard

Fasten 3 bolts in blade guard
Note: make sure that saw blades are used intended for dry use
and suited for the material which has to be cut ask your carat
dealer for advice!
13. HORIZONTAL AND VERTICAL CUTS
Horizontal cuts:

Before making a horizontal cut always check for hidden
water, gas pipes and electricity loads in the wall!

Place machine with wide wheel base on the wall

Start the machine

Slowly push the back part of the machine in the material

until small wheel base is on the wall

Always cut from right to left by pulling the machine back
Vertical cuts:

Before making a vertical cut always check for hidden
water, gas pipes and electricity loads in the wall!

Place machine with wide wheel base on the wall

Start the machine

Slowly push the back part of the machine in the material

until small wheel base is on the wall

Always cut from top to bottom

14. RECYCLING

According to the European regulation 2002/96/EC, Carat is
responsible to recycle
You are therefore requested to return old Carat to your local
dealer

15. WARRANTY

For the SLX-150, a guarantee period of 12 months applies
from the date of purchase. Guarantee claims can only be
accepted if purchase invoice can be shown. The guarantee
includes the repair of defects which have occurred and can be
linked to material or manufacturing faults.
Not covered by guarantee:

Defects or damages which are caused by incorrect use or
connection.

Machine overload.

When maintenance has been carried out incorrectly or
badly.

Information in the manual has not been properly followed.

The machine is used by unqualified persons.

If the machine is used for purposes for which it is
unsuitable.

The machine is repaired using non original parts.

If the serial plate is damaged or deleted.

If defects are caused by fire, damp and/or transport
damage
Manual SL-1502
old electric drill motors.
FRANCAIS
CONTENU
1. Informations techniques
2. Description de la machine
3. Tension
4. Pièces importantes
5. Instructions pour une sécurité maximale
6. Marche / arrêt
7. Surcharge
8. Balais de charbon
9. Evacuation de la poussière
10. Système du guide laser
11. Réglage de la profondeur de coupe
12. Montage des disques
13. Coupes horizontales et verticales
14. Recyclage
15. Garantie
16. Vue éclatée
7
8
8
8
9
9
9
9
9
9
9
10
10
10
10
10
24
Versie 01-2011