Skywalker Trampolines SBT48.4 Manual Del Usuario página 8

ASSEMBLY
STEP 3
Next, connect all the frame pieces together.
Note: If the bottom of the legs are leaning noticeably inward and not flat on the ground, you will need to
disassemble and go back to Step 2. Make sure you assemble with the larger side of the frame tube placed into
the left side of the leg socket with the top of the leg pointing at you and the bend facing away from you.
STEP 4
6
Mat with Net (x1)
Thread the stretch bands
all the way through the
tab until the ball sits
against it
1
Trust us, your hands will
thank you for doing it this
way
3
Place the mat with net (6) on the ground inside the frame. Make sure
the zipper of the door is centered between two legs. Then, using one
elastic with ball (8) attach the mat to the frame in location A. Repeat
this step to attach 5 remaining elastic bands in locations B-C-D-E-F
as shown. Follow the example below for the easiest way to attach
the stretch bands.
8 Elastic with
Ball (x6)
One elastic band should be centered in between each leg.
Pull stretch band under
and over the Frame Tube
and onto the ball
2
Spend time adjusting the
stretch bands so the ball
is underneath the frame
tube
4
D
E
8
B
A
F
C