Insert The Batteries - TFA 60.2546 Instrucciones De Uso

TFA_No. 60.2546_anl_04_20 02.04.2020
TUNE – Radio-controlled alarm clock with radio
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Protect it from moisture.
5. Elements
A: Display (Fig. 1):
A 1: Time
A 3: Alarm symbol
A 5: Daylight Saving Time symbol
A 7: Radio mode
B: Buttons (Fig. 2):
B 1: VOL– button
B 3: MODE button
B 5: SNOOZE button
22
15:01 Uhr Seite 12
A 2: AM/PM
A 4: DCF reception symbol
A 6: Alarm mode
A 8: Snooze symbol
B 2: VOL+ button
B 4: DOWN button
B 6: UP button
– 22 –
TUNE – Radio-controlled alarm clock with radio
C: Housing (Fig. 1+3):
C 1: Battery compartment C 2:
C 3: Power adaptor jack C 4:
C 5: Speaker
6. Getting started
• Remove the protective film from the display.
• Connect the attached power adapter to the alarm clock. Insert the power adapter pin into the device jack and connect the
plug to a wall socket. Important! Make sure that your household voltage is no more than 240V! Otherwise your device
may be damaged.
• The device will alert you with a beep.

6.1 Insert the batteries

• The batteries will operate as a backup power source in case of power failure.
• Insert two new batteries AAA 1,5 V into the battery compartment. Make sure the polarity is correct.
• Close the battery compartment again.
6.2 Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display.
USB Port
LIGHT switch
– 23 – 23