Parrot ANAFI Ai Manual De Instrucciones página 15

CANADA DECLARATION OF CONFORMITY: ANAFI Ai &
PARROT SKYCONTROLLER 4
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Operation of this device in the UNII-1 is restricted to indoor use
only. (For Canada).
ANAFI Ai (drone)
Radio Frequency Exposure Statement for IC:
The device has been evaluated to meet general RF exposure
requirements. The device can be used in mobile exposure
conditions. The min separation distance is 30cm.
SKYCONTROLLER 4 (remote control)
This EUT is compliance with SAR for general
population/uncontrolled exposure limits in IC RSS-102 had been
tested in accordance with the measurement methods and
procedures specified in IEEE 1528 and IEC 62209. This
equipment should be installed and operated with minimum
distance 0 mm between the radiator and your body. This device
and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC DECLARATION OF CONFORMITY: ANAFI Ai &
SKYCONTROLLER 4
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help
15