Olimpia splendid SHERPA SHW S1 200 Manual Del Usuario página 56

2. button
By pressing this button for 2" when the unit is in standby mode, the unit is turned 'ON' and runs on the setting mode. The
running mode, set temperature and water temperature, clock time and timer situation are displayed on the screen.
By pressing this button for 2" again when the unit is running, the unit is turned 'OFF' and enters into the standby mode.
3. and buttons
- These are the multi-purpose buttons. They are used for temperature setting, parameter setting, parameter checking, clock
adjustment and adjustment of the timer.
- During running status, press
- By pressing these buttons when the unit is on clock setting status, the hour(s) and the minute(s) of the clock time can be
adjusted.
- By pressing these buttons when the unit is on timer setting status, the hour(s) and the minute(s) of the timer 'ON'/'OFF' can
be adjusted.
- Check and adjust the set parameters:
1) When the unit is 'OFF' or 'ON' (not on clock and timer setting status), short press
parameter checking. Select the parameter by pressing
2) When the unit is 'OFF' (not on clock and timer setting status), press
password confirming each field with
pressing or
and confirm with
For example: parameter 01, the relating value is 5°C:
Once the parameters have been set; the user cannot change the parameters optionally. Please ask a qualified
service person to do this when required.
- By pressing and
- By pressing
and
4. and buttons
Clock setting:
- Press button to entry the clock setting interface: hour icon "88:88" flashes;
- Press the and
- Press the
and
The set clock time is displayed.
22
or button to adjust the setting temperature directly.
and short press button to access the parameter value. Press
button. Press to exit.
buttons at the same time and hold for 5 seconds, the buttons are locked.
buttons at the same time and hold for 5 seconds again, the buttons are unlocked.
buttons to set the exact hour(s) and press
buttons to set the exact minute(s) and press
or button. Press
button to entry the installer parameter setting. Select the parameter by
to confirm: minute icon "88:88" flashes;
to confirm and exit.
button to entry the user
to exit.
and buttons together for 2" and insert the
or button to adjust the value