Maintenance And Inspection; Environmental Conditions - Druck DPI 610E Manual De Inicio Rápido

1.4 Over-voltage categories
Over-voltage
Category
This is the least severe over-voltage transient.
CAT I equipment cannot be directly connected
CAT I
to the mains power. An example of CAT I
equipment is a process loop powered device.
This is for single phase electrical installation.
CAT II
Examples are appliances and portable tools.
1.5 Repair
WARNING
Servicing or repairing the
equipment may result in damage to property
and serious personal injury (including death).
It is important that service and repair are only
carried out by a Druck authorized service
provider.
Repair activities undertaken by unauthorized
personnel may invalidate the equipment
warranty. Druck cannot be held liable for any
damage (including damage to the equipment),
monetary fine or personal injury (including
death) that may occur during or as a result of
service maintenance or repair work
undertaken by an unauthorized service
provider.
Internal component may be under pressure or
present other hazards if abused.
For details, please see:
bakerhughesds.com/druck/global-service-support

1.6 Maintenance and Inspection

The product should be periodically inspected for signs of
damage (e.g. case cracking, pressure connector damage)
or pressure leakage prior to use to ensure continued safe
working.
INFORMATION
cause failure to maintain pressure after
pumping or by visible fluid leakage (hydraulic
units) or audible air leakage (pneumatic units).
For details, please see:
bakerhughesds.com/druck/global-service-support
Clean the surface of the instrument should using a damp
cloth with water and mild detergent. Do not submerge the
instrument in water.
To calibrate the instrument, or for further details please
contact: bakerhughesds.com/druck/global-service-
support
Description
Pressure leakage may be
1.7 Disposal
For more information contact one of:
• Our Customer Service Department:
Druck.com/expert
• Your local government office

1.8 Environmental Conditions

Condition DPI 610E
Not for permanent
Outdoor Use
installation outdoors
IP Rating IP54
Operating
-10 to 50°C
Temperature
Storage and
Shipping -20 to 70°C
Temperature
Altitude -300 to 2000m
0 to 95% relative
Operating humidity humidity (RH) non-
condensing
Over-voltage
2
category
Pollution degree 1
1.9 Media Compatibility
Pressure FS
0 to 3.5 bar
Differential sensor reference
port
7 to 1000 bar
Note: Sensors rated up to 3.5 bar (including differential)
are exposed. Sensors rated between 7 and 1400 bar are
diaphragm isolated.
Note: Only fluids that are compatible as per above table
should be used. This is to ensure the integrity of the
pressure sensor and avoid fluid leakage.
English–DPI 610E Quick Start & Safety Manual | 3
Do not dispose of this
product as household
waste.
Use an approved
organization that collects
and/or recycles waste
electrical can electronic
equipment.
Mains Plugtop
149M4334 1
For indoor use only
IP20
0 to 45°C
-20 to 70°C
-300 to 2000m
0 to 95% relative
humidity (RH) non-
condensing
2
1
Media Compatibility
Fluids compatible with stainless
steel 316L, pyrex, silicon, gold,
aluminum and structural
adhesive
Fluids compatible with Stainless
Steel 316L and 304, Pyrex,
Silicon and Structural Adhesive
Fluids compatible with stainless
steel 316L and Hastelloy C276
Copyright 2022 Baker Hughes Company.