FONESTAR ASH-1200 Manual De Usuario página 3

2.- BATTERY: battery and charging status indicator lights. When the power cable is connected, the
battery is charged and these indicators turn on and off. When charging is complete all indicators are
permanently lit. If the cable is not connected, these indicators will show the amount of charge in the
battery when the amplifier is switched on
3.- POWER: amplifier on/off switch and indicator light.
4.- MASTER: volume control of the general output and OUTPUT output when LINKSET is in MASTER
position.
5.- TREBLE:boosts or attenuates the high frequencies.
6.- BASS: boosts or attenuates low frequencies.
7.- VOICE PRIORITY: selector switch to activate/deactivate the priority of the microphone inputs (MIC IN
input and MSHRM-1200 modules).
8.- AC socket for power cable connection.
9.- EXT SPK: amplified output for connection of 4 Ω passive speakers, 6.3 mm jack plug.
10.- FUSE: fuse holder.
11.- UHF speaker connection:
a.- Cover for installation of the MSHTM-1200L/MSHRM-1200L UHF master output transmitter/
receiver module (optional). For more information see the section on these models.
b.- BROADCAST: operation selectors only when the MSHTM-1200L and MSHRM-1200L option
modules are installed. Set TX to the loudspeaker to which the sources are connected, and RX
to the loudspeaker which will receive the signal. For more information, see the section on these
models.
c.- VOLUME: On/Off and volume control for the MSHTM-1200L and MSHTM-1200L modules when
installed. If these modules are not installed, this control should remain in the OFF position.
12.- Connections and controls for multiple speakers:
a.- INPUT/OUTPUT: balanced line input and output, XLR connectors. When using a second
loudspeaker (LINK INPUT in SLAVE position), connect the OUTPUT output of the main loudspeaker
(LINK INPUT in MASTER position) to the INPUT input.
b.- LINK SET: operating selector when using more than one loudspeaker connected via the INPUT
and OUTPUT connections. MASTER position for the main speaker (the volume control of the
OUTPUT output will be adjusted with the MASTER control); and SLAVE position for the secondary
speaker that will receive the signal via INPUT (the volume control will be adjusted with the SLAVE
control).
c.- SLAVE: speaker volume control when LINK SET is in SLAVE position.
13.- Microphone input:
a.- MIC INPUT: balanced microphone input, combo connector (XLR and 6.3 mm jack).
b.- MIC GAIN: microphone input gain control.
c.- MIC TONE: control of the tone effect applied to the microphone inputs (MIC IN input and
MSHRM-1200 modules).
d.- MIC ECHO: control of the echo effect applied to the microphone inputs (MIC IN input and
MSHRM-1200 modules).
14.- Integrated player:
a.- Player with independent playback and volume controls.
b.- LINE IN: stereo line input, 2 x RCA connector.
c.- LINE: LINE IN input volume control.
15.- Cover for installation of CD/USB/SD/MP3 player CDM-1200 (optional). For more information, see the
section on this model.
16.- UHF microphone receiver module (MSHTM-1200).
- 3 -
EN