RADEMACHER Troll Comfort 3D Manual De Instrucciones página 8

WARNING! – The overloading of the controller can lead to personal injury and
the destruction of the device caused by short circuiting.
The maximum switching capacity must not be exceeded. Please observe the details in
the "Technical Specifications".
WARNING! – Using an incorrect installation housing can lead to personal
injury and property damage (electric shocks / short circuiting).
• Only use the installation housing provided to connect and install the controller.
• Installation housings of other RADEMACHER products are not compatible, such as
other controllers.
WARNING! –The connection of a second phase to E1 or E2 will cause
the controller to be destroyed.
• When using the inputs [E1 / E2], they must always be connected to the same phase
[ L ] as the supply voltage.
• If another phase is connected, the incorrect mains voltage (380 V / 50 Hz) will be
applied to the inputs and damage the controller.
• Follow the pin assignment detailed in the connection diagram.
7. Important information prior to electrical connection
and installation
WARNING! – You must set the end points of the tubular motor before installing
it and making the final electrical connection otherwise malfunctions may
occur.
It is essential that you set both end points of the tubular motor if no end points have
been set yet.
8. Dismantling
DANGER! – There is a risk of fatal injury resulting from electric shock when
touching electrical components.
• Disconnect all phases of the mains power lead and secure it to prevent any re-
connection. Check that the system is de-energised.
A_VBD_100-013-1_Steuerungen_105x148_8x_1c_220204.indd 8
8
EN EN
04.02.22 13:19