Sauder 427654 Instrucciones De Montaje página 11

Step 5
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below.
Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (1) to the LARGE SIDE BRACES (R). Use six 1/2" FLAT HEAD SCREWS (24).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES will be used later
for the DRAWERS.
24
Open end
Open end
427654
1
1
R
www.sauder.com/service
Push the release lever in and pull the SLIDE from the RAIL.
1
1/2" FLAT HEAD SCREW
1
R
7
2
Open
end
24
(6 used in this step)
Page 11