Sauder 426908 Instrucciones De Montaje página 8

Step 2
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (35MA) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S)
through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWERS.
35MC
Push the black lever in and pull the SLIDE from the RAIL.
2
1
Open end
Page 8
3
3
B
2
1
426908
35MA
2
3
A
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
7
1
1
2
3
www.sauder.com/service
Open end