Publicidad
Step 9
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the RIGHT END (L) and UPRIGHT (K).
Use twelve 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to find the other holes that lines up with the holes in the END and
UPRIGHT. Turn a SCREW into those holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Open end
Page 14
2
Pull the black lever down and pull the SLIDE from the RAIL.
1
1
K
www.sauder.com/service
1
1
1
L
1/2" PAN HEAD SCREW
(12 used in this step)
7
Open end
20
427707
Publicidad
