Machine Information; Technical Specifications - VONROC LL503DC Traducción Del Manual Original

EN
LL503DC / LL505DC red laser:
Warning - Laser beam
Never look into the light beam
according to EN60825-1: 2014;
λ λ : 620-690 nm; P< _ 1mW
LL504DC / LL506DC green laser:
Warning - Laser beam
Never look into the light beam
according to EN60825-1: 2014;
λ λ : 510-530 nm; P< _ 1mW
SAFETY WARNINGS FOR BATTERY
a) Do not open the battery. Danger of shortcircuiting.
b) Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
c) In case of damage and improper use of the bat-
tery, vapours may be emitted. Ventilate the area
and seek medical help in case of complaints. The
vapours can irritate the respiratory system.
d) Use the battery only in conjunction with your
Vonroc product. This measure alone protects the
battery against dangerous overload.
e) The battery can be damaged by pointed objects
such as nails or screwdrivers or by force applied
externally. An internal short circuit can occur and
the battery can burn, smoke, explode or overheat.
SAFETY WARNINGS FOR CHARGER
Intended use
Charge only LL802AA type rechargeable Battery
pack with the charger. Other types of batteries may
burst causing personal injury and damage.
a) The appliance is not to be used by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experien-
ce and knowledge, unless they have been given
supervision or instruction.
b) Children being supervised not to play with the
appliance.
c) Do not recharging non-rechargeable batteries!
d) During charging, batteries must be placed in
the well ventilated area!
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
8
Laser Class 2
Laser Class 2
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The line laser is intended for determining and chec-
king horizontal and vertical lines onto the wall and
is therefore designed for aligning objects such as
kitchens, walls, ceilings, tiles or pictures. The line
laser is suitable for indoor and outdoor use.

TECHNICAL SPECIFICATIONS

Model No. LL503DC LL505DC LL504DC LL506DC
Number of lines 8
Direction of
2x 360° 3x 360°
beams
Colour of laser
Red
line
Laser Wave-
620 - 690 nm
length
Laser class II (<mW) acc. To EN60825-1: 2014;
Working range
20m
(diameter)*
Accuracy
Self-levelling
range
Levelling time
Protection
Tripod connec-
tion device
Tripod connec-
tion bracket
Recommended
tripod
Operating time,
18-20
max. (all laser
hours
beams on)
Operating
temperature
12 8 12
2x 360° 3x 360°
Green
510 - 530 nm
40m
± 0.3 mm/m
± 4°
3 s
IP 54
1/4"
1/4" and 5/8"
LL801AA
13-15 13-15 8-10
hours hours hours
-10~40 °C
WWW.VONROC.COM